Quality guarantee terms

1. Engine and EFI set (Oxygen sensor, ECU unit, Fuel pump, Injector, Valve body, Other sensor) warranty at a mileage of 30,000 kilometers or 3 years, whichever come first. Quality guarantee is valid from the date of purchase of the vehicle. Refer the warranty date specified in the owner’s manual.
2. Equipment warranty and external parts at a mileage of 10,000 kilometers or 1 year, whichever come first. Quality guarantee is valid from the date of purchase of the vehicle. Refer the warranty date specified in the owner’s manual.
3. Guarantee for battery, rear shock absorber and tire for a period of 6 months or a mileage of 5,000 km, whichever come first. Quality guarantee is valid from the date of purchase of the vehicle (Refer the terms of the warranty from the local manufacturer).
4. When your motorcycle have quality problem. You can go to use the warranty by bringing the motorcycle and the warranty book to the distribution center & service appointed by the company. Your vehicle will be modified, adjusted or replaced with the defective part without charging the price of spare parts and repair wage.

    Chassis number

Chassis number is on the right pipe of chassis.

① Tail light                 

② Seat                      

③ Fuel tank

④ Headlight               

⑤ Front shock absorber

⑥ Horn

⑦ Rear brake pedal     

⑧ Muffler                   

⑨ Rear shock absorber

① Signal light (High beam)                    

② Speedometer

③ Signal light (Neutral)                        

④ Signal Light (Turning light)

⑤ Signal light (Fuel level warning)         

⑥ LCD Screen

Left handlebar switch

① Dimmer switch

Press the switch to position     For change to high beam.

Press the switch to position   For change to low beam.

② Turning light switch (Type – Push for cancel)

Move the switch to the direction (Right) The turn signal (Right) will work.

Move the switch to the direction (Left) The turn signal (Left) will work.

Press the switch to the middle area. For turn off the turn signal.

③ Horn switch    Press the horn switch, when the horn signal is to be used.

Ignition switch

ON  : Open the entire electrical system. The key cannot be removed.

OFF  : Close the entire electrical system. The key can be removed.

For the battery attached to the motorcycle. It is a semi-dry battery. The battery of this type is filled with electrolyte and charge it from the battery manufacturer factory However, in order to extend the life and make the battery most efficient to use. It is therefore necessary to charge the battery regularly, When the battery voltage is less than 12.5 v.

In normal driving, The battery will be fully charged by the motorcycle charging system. Whenever you use a motorcycle for a short or very short time, the battery should be recharged. As the battery is self-discharging even though we have turned off the ignition to the OFF position, but with the rising temperature Including the supply of power to various devices causing the battery to discharge electricity continuously.

Remove the spark plug and clean it. According to the maintenance schedule by using a small wire brush scrub clean.

Adjustment of driving chain

• Set the motorcycle upright on a level surface.
• Loosen fixing nut of the rear axle ①then tighten the adjusting screw ②so that the chain slack is 20 – 30 mm. (tighten the adjustment screw same both side)
• The distance of markings on the swing arm ③ must be same on both sides
• Double check the chain tension, Then tighten nut ①

Procedure for removing the air filter

• Remove the screw on the left cover ①, Then open the left cover.
• Remove the screw of the air filter cover ②
• Open the air filter cover and take out the air filter to clean.
• Blow the airflow from outside to inside follow the arrow.